SET UP THE EQUIPMENT

SMART Board Interactive Whiteboard Basics
Notebook Software Basics

Module 1

SET UP THE EQUIPMENT

LEARN

1 Vital Components Needed

Computer

Projector

Smart Board

Tray Pens and Eraser

2 Power Up Equipment

Turn on Projector

Power up Computer
and Move Smart Board and Projector into Place

Focus Image

Place eraser and pens in tray

Tips:

You'll know the smart board is connected and activated when the Ready Light on the right side of the Smart pen tray turns green.
Log on, if required, using the computer keyboard.
Make sure all the pens and the eraser are placed securely in the pen tray.
The board is now touch sensitive and you can open any application available on the attached computer.

PRACTICE:

1 Using the checklist below -- Check to see that you have all components needed

	Yes	No
Computer with Windows Operating System
Multimedia Projector
Smart Board
4 Tray Pens
1 Tray Eraser

2 Perform each task in the table below to set up your equipment.

Tasks	Yes	No
1. Turn on projector
2. Move Smart Board and Multimedia Projector into place
3. Boot up computer
4. Focus projected image on board
5. Place the 4 pens and eraser in the Smart Board tray

Good Job! You're now ready for Module 2.

Module 2